This error occurs due to the lack of access by the vag eeprom programmer to the file (or its creation) C: \ mm.dat, which records the history of the read access codes to the Motometer / Bosch devices. – If the program, when reading the firmware of the Motometer / Bosch tidy, swears EEprom area blocked, can’t read it … then this does not mean that the tidy is blocked!
USB Serial Port (COM23) – double click on it and open the second tab Port Settings (Port Settings):Ĭlick the Advanced … button and go to the advanced settings, where you must select the virtual COM port # 1 or # 2 (Com1 or Com2)! The vag eerpom programmer does not work on other virtual com ports.įor proper operation, you need to go to Options and select USB (for some it works on the Com-port to which the VCP driver is configured).Īctually, this is where the settings are completed and the firmware (dump) of the tidy should be read as described in section 4.a) in the record about the installation of the W8 tidy We go to the Device Manager, in the Pors (Com & LPT) – Ports section we find something like: Installation (update) of the VCP driver is completed, now you need to configure it. We are waiting for the driver installation (update) and click OK at the end: In the window that appears, specify the path where the files were unpacked (see above in section A) of the VCP driver. In the next window select Browse my computer for driver software (Specify the path to the driver manually):
Press the right button on this new device (to update the driver, press on the existing one in the Pors (Com & LPT) section – Ports: If the driver is not installed, a line will appear in unknown devices. When the cable is connected, a new line will appear in the Ports (COM & LPT) section if the driver is already installed Start – Right click on Computer (Computer) – Select Device Manager (Device Manager): We remember the path to this folderī) We connect the KKL cable to the USB connector of the computer and remember which USB connector it was plugged into! The USB device is configured for a specific USB connector, so you need to connect the cable to one connector.
Unpack the downloaded archive (or run the exe file to unpack) into a specific folder. We find for the required operating system and download (For example, the Windows line and the x86 column (32-bit).įor the ch34x chip, I advise you to take the driver from the site of the ch340 / ch341 chip manufacturer:Īt the moment, the latest driver version for ch34x 3.5.
In the table: Currently Supported VCP Drivers
More details about installing and updating the driver (the procedure is very similar) in Win 7:Ī) Find a VCP driver for your chip on the Internet.
This is a USB device driver that you plug into a computer that simulates the operation of this device on a virtual COM port (hopefully clear)). If you have not bought a cable yet, then it is better to take with an FTDI chip (ft232.)!ĭepending on the type of chip in the cable, we put a VCP driver under it.
Install the appropriate VCP driver for your KKL cable.īecause KKL cable can be made on different chips (FTDI or ft232., Ch34x, …), then I recommend just disassembling the cable and looking at the type of chip in your cable (just unscrew 4 screws). VAG EEPROM Programmer 1.19g Free Download – are not suitable for reading / writing device firmware!ĭownload the VAG epprom programmer 1.19g program (version 1.19G, because only this version learned to work through the VCP driver). Vag k + can commander 1.4 With a USB connector.Ĭables like vcds / Vasya 10.6, 11.11, 12.12, 18.9, etc. KKL cable (cable working through the K-line) is suitable